Part Number Hot Search : 
STB4080C 287RF 12IO1 SM8205 N4124 A103M CXA3188N RA121
Product Description
Full Text Search
 

To Download TPAC400P Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 400 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES TPAC400P SERIES
FEATURES:
400W 6U X 8HP EUROCARD PACKAGE MEET IEC1000-3-2 HARMONIC CORRECTION INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / CLASS B CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG
TOTAL POWER INT'L
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 90-264Vac. Input On/Off switch: Option. Power Factor Correction: Meet Harmonic Correction IEC1000-3-2.Power Factor typ. 0.99. Input Connector: Positronic 47-pin PCIH47M400A1. Input Frequency: 47-63Hz. Inrush Current: Typ. 30A @ 230Vac.(Active). Input Current: 4.65A@115Vac/2.3A @230Vac. Dielectric Withstand: Meet IEC950 regulation. Transient Protection: MOV withstands transient as specified by EN61000-4-4 level 3. EMI: Meet EN55022 Class B. Hold-up Time: 30mS @ 115Vac,34mS @ 230Vac. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection (OTP): Installed NTC and thermostat for thermal sensor at [DEG#] pin. Power OK: Installed at all outputs. Leakage Current: Typ.0.7A @ 230Vac.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Power: Typ. 400-450W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: VO1 & VO2 typ. 0.5%. VO3 typ. 1.0%, VO4 typ. 3.0%. Noise & Ripple: Typ. 1% peak-peak or 50mV,which is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1, 2 &3. Output Trim: Electrical trim available at VO1/2. [ADJ #]. Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs and third-wire current sharing method for N+1 redundancy operation. Current Sharing: Third-wire current sharing at VO1,2 & 3. DC OK Signal: Available for all outputs. Power OK Signal: Available for all outputs. Over Current Protection (OCP): Installed at each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typ. 120-130% max. load. Consult the factory for special OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 80-83 %. Switching Frequency: 120K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 200mV and returns to within 1% less than 250S for 25% load-change. Safety Standard: IEC60950. Construction: Eurocard 6U X 8HP X 160mm CompactPCI format. Front Panel with Extractor handle. Operating Temperature: 0 to +50 C at full load with specified air flow. Derates linearly to 50% at +70 C. Storage Temperature: -40 to +85 C. Temperature Coefficient: Typ. 0.04% / C. Cooling: At least 400lfm/20cfm moving air is required to achieve full rating power 400W in a confined area. Power Density: 3.98 Watts/ Cubic Inch.
Remark: All measurements are at nominal input, full load and +25C unless otherwise specifications.
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1-
OUTPUT VOLTAGE/CURRENT RATINGS CHART
QUAD OUTPUT
MODEL NO. TPAC400P-490 MAIN +VO1 @# Min. 2.0A Typ. 40A Volt. +5V Max. 55.0A AUX. +VO2 @# Min. 0A Typ. AUX. +VO3 #@ AUX. -VO4 Volt. Max. Min. Typ. Volt. Max. Pk. Min. Typ. Volt. Max. Pk. 0A 10A +12V 14A 15A 0A 2A -12V 4A 5A
30A +3.3V 55A
Symbol: "" OVP built-in. "@" Adjustable. "#" Remote sensing. "" 3rd-wire Load Sharing. "" Installed with Or-ing diode. "" Magnetic Amplifier. "" Installed with Post-regulator. . Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 1.7kg (3.75 lb.)
INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT
AC INPUT LNG 47 46 45 QUAD OUTPUT VO1 S+ S- Adj. C.S. 1,2, 3,4 30 34 29 35 VO2 13,14, 15,16, 17,18 S+ Adj. C.S. VO3 33 32 41 20 STATUS/CONTROL S+ C.S VO4 DC COM EN# DEG# INH# FAL# 5,6,7,8,9, 36 44 21 10,11,12, 27 38 39 42 19,24
ASSIGNMENT CNTR &PIN #
Mating connector: PCIH47F400A1.
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -2-


▲Up To Search▲   

 
Price & Availability of TPAC400P

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X